Answering system
121
Answering system settings
Voice guide to set Answering system
This feature is an alternative way for you to do the basic setup of the
answering system. You can follow the voice guide to record your own
announcement, set the number of rings, and set the message alert tone.
This feature is only available in the telephone base.
1. When the telephone base is in idle mode, press MENU/SELECT.
2. Press qCID or pDIR to scroll to Answering sys, then
press MENU/SELECT.
3. Press qCID or pDIR to scroll to Voice guide, then press
MENU/SELECT.
4. You hear a voice prompt “This voice guide will assist you
with the basic setup of your answering system.“
5. Set up your answering system by inputting the
designated numbers, as instructed in the voice guide.
Notes:
f You can press CANCEL to quit the voice guide at any time.
f If the system does not receive any input, it will play an alert message. If there is still no input, it will announce
“Sorry, I still have not received any input. If you want to restart the voice guide, please enter the menu and select
Voice guide under Answering system. Good bye.”
f After a power outage, the system prompts you to set the date and time, and Smart call blocker. After these
settings are done or skipped, the system will prompt if you want to set up the answering system via voice guide.
Press MENU/SELECT to start the setup.
f If the answering system is off and there is an incoming call, the system answers after ten rings and announces, “Please
enter your remote access code.” For more information about remote access, see page 124
Answer ON/OFF
>Voice guide
Setting up
Answering sys
...
To Next Page
Loading...
Need help?
General
