Multiple handset use
Handset locator
The handset locator feature is useful if you
misplace any handsets.
To start the paging tone:
f Press /FIND HS on the telephone base to
start the paging tone on all handsets for 60
seconds.
Note: If you press
OFF/CANCEL or MUTE/DELETE on a
handset, the ringer of that handset stops, but the paging to the rest of the handsets
continues.
To stop the paging tone:
f Press
PHONE/FLASH, /SPEAKER, or any dialing
key (0-9, TONE or #) on the handset(s).
-OR-
f Press /FIND HS or CANCEL on the telephone base.
Join a call in progress
When a handset or the telephone base is already on a call and you would like
to join the call, press
PHONE/FLASH or /SPEAKER on your handset or
/SPEAKER on your telephone base.
To end the call using a handset, press
OFF/CANCEL or place the handset in
the telephone base or charger. To end the call using the telephone base,
press /SPEAKER. The call does not end until all handsets and the telephone
base hang up.
Note: You can use up to four system handsets and the telephone base at the same time on an outside call.
49
Multiple handset use
**Paging**
To Next Page
Loading...
Need help?
General
