Answering system
Remote access
You can reach your answering system remotely by dialing your home
telephone number from any touch-tone telephone.
To remotely reach your answering system:
1. Dial your telephone number from any touch-tone telephone.
2. Once the system answers, enter the two-digit remote access code (19 is
the default code. See page 124 to change it).
f The system automatically announces the number of new or old
messages (if any), and then begins to play them.
3. You can also enter the following remote commands:
Remote commands
1
Press to listen to all messages.
2
Press to listen to new messages only.
3
Press to delete the current message (during playback).
33
Press twice to delete all old messages.
4
Press to repeat the current message (during playback).
5
Press to stop any operation (including recording).
*
5
Press to listen to a list of remote commands.
6
Press to skip to the next message (during playback).
*
7
Press to record a new announcement.
8
Press to end remote access (the call will be terminated).
0
Press to turn the answering system on or o.
4. Hang up or press 8 to end the calls.
137
To Next Page
Loading...
Need help?
General
