Answering system
Answering system settings
Remote access code
To access your answering system remotely from any touch-
tone phone, you need to enter a two-digit number (00-99). By
default, the remote access code is 19.
To change the remote access code:
Using a cordless handset or the telephone base:
1. When the handset or telephone base is in idle mode,
press MENU/SELECT to enter the main menu.
2. Press qCID or pDIR to scroll to Answering sys, then
press MENU/SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then
press MENU/SELECT.
4. Press qCID or pDIR to scroll to Remote code, then press
MENU/SELECT.
5. Use the dialing keys to enter a two-digit number. Press
MUTE/DELETE to backspace and delete a digit.
6. Press MENU/SELECT to save the setting. You hear a
confirmation tone.
REMOTE CODE
19
Answer ON/OFF
>Ans sys setup
Play messages
>Answering sys
Play messages
>Answering sys
Voice guide
>Ans sys setup
REMOTE CODE
19
124
To Next Page
Loading...
Need help?
General
