Answering system
133
Message playback
When messages are playing on the handset:
f Press qCID/VOLUME or pDIR/VOLUME to adjust the message playback
volume.
f Press 6 to skip to the next message.
f Press 4 to repeat the message. Press twice to hear the previous message.
f Press MUTE/DELETE to delete the message.
f Press 5 or
OFF/CANCEL to stop the playback.
f Press /SPEAKER to switch between speakerphone mode and
handset mode.
f Press
PHONE/FLASH to stop playback. The screen shows Call back?, then
press MENU/SELECT,
PHONE/FLASH, or /SPEAKER to call back the caller
if the caller’s number is available. If the dialing format used is not correct,
then use the option, as mentioned below, to choose the correct dialing
format before calling back the caller.
f Press MENU/SELECT to pause playback and show the caller ID information
if available. From here, you can press # (pound key) repeatedly to show the
desired dialing option (page 76), then press
PHONE/FLASH to call back
the caller. You can also press
OFF/CANCEL to resume playback. If you do
not call back within ten seconds, message playback resumes automatically.
To Next Page
Loading...
Need help?
General
