55
Appendix
The messages on
the system are
very difficult to
hear
• Press VOLUME on the telephone base to increase the
speaker volume.
Troubleshooting
“Time and
day not set”
prompts
• You need to set the answering system clock (page 35).
The answering
system does not
respond to remote
commands.
• Make sure your remote access code is correct (page 42).
• Make sure you are calling from a touch-tone telephone.
When dialing a number, you should hear tones. If you
hear clicks, then it is not a touch-tone telephone and
cannot activate the answering system.
• The answering system may not detect the remote access
code when your announcement is playing. Wait until the
announcement is over before entering the code.
• There may be interference on the telephone line you are
using. Press the dial pad keys firmly when dialing.
To Next Page
Loading...
