C
Check the Wireless Signal
Wait a few seconds for the Signal
Strength light to turn on, while
your device connects to the
cellular network.
Conrm Signal Strength light
has four (4) lit bars for optimal
performance. Fewer bars
indicate a moderate signal,
which may be sucient.
NOTE: If you do not see four (4) lit bars, you may want to choose another
location in your home, such as near a window or outer wall.
STEP 1: Set Up Your Device (continued)
B
Turn On Your Device
1. Plug the power cord in to an electrical wall outlet.
2. Connect the other end of the power cord to the Power Input port on
the back of your AT&T Wireless Internet device.
3. Slide the On/O switch to the ON position. The Power light should be
solid green.
6
On/O
To Next Page
Loading...
