TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus February, 1988
7. Plug in Telephone Line Cord
• Push one end of the telephone line cord through the rubber grommet and into the
jack just below the chassis cover. If the rubber grommet has not been cut to allow
for the cord and plug, see page 14. Plug the other end into a working telephone
line jack. Pick up the handset and listen for dialtone. Dial a number. If the call is
placed successfully, the phone may be installed permanently.
8. Disconnect Power Transformer and Power Wires
• Unplug the power transformer from the outlet and remove the power wires from the
transformer.
• Remove the front cover of the phone, following instructions on page 13.
• If your power supply is equipped with a switch, turn the power switch to OFF.
• Hold the power supply board against the housing and disconnect the power wires
from the power supply board.
NOTE You may have to remove the coin chute to
disconnect the power wires from the power supply board
9. Disconnect the telephone line cord.
1 0. Replace Front Cover
• Plug the dial assembly cord from the front cover into its socket underneath tha
internal keypad.
• Slide the front cover back onto the base housing.
• Secure the front cover to the base housing by turning the T-key clock·N ise.
• Remove the T-key.
• Using the lock key in the lock on the right side, lock the front cover.
Your AT&T Private Pay Phone
Plus is now ready to be installed at its installation site. We
recommend that rate programming be completed before the phone is installed.
Owner Manual
Page 17
To Next Page
Loading...
