TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus
February, 1988
4. Removing and Replacing the Coin Chute
To Remove the Coin Chute:
1. Turn power OFF.
2. Refer to Figure 24.
3. Loosen the mounting screw on the plastic protective cover of the chassis. Remove the
plastic protective cover by pulling the bottom of the plastic cover forward, and then lift
the plastic cover off the base.
4. Unlatch and unplug the coin chute plug from its connector underneath the internal
keypad.
5. Push up the latch that is located above the coin chute. Then release the spring
located above the coin chute (between coin chute and base housing) by pushing the
spring with your thumb.
6. Remove the coin chute.
COIN CHUTE LATCH
Figure 24 Coin Chute
To Unjam the Coin Chute:
2 TILT TOP FORWARD
3 LIFT UP AND OUT
COIN CHUTE
COIN CHUTE CONNECTOR
1. Remove the coin chute. (Refer to "Remove the Coin Chute" section above if
necessary.)
Owner Manual
Page 65
To Next Page
Loading...
