TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus
C. Mounting the AT&T Private Pay Phone Plus with an Enclosure
Mounting Phone to the Econo Shelf Enclosure
February, 1988
The Econo Shelf is shipped fully assembled for ease of installation. It has a built-in directory
shelf that can hold two 4-inch telephone directories side-by-side. The mounting site for the
Econo Shelf must be at least 31 inches in height and 23 inches in width. Ideally, the
mounting (wall) bracket of the shelf should be mounted 49 inches from the floor to obtain a
coin slot height of 4-1 /2 feet.
The mounting area must be a vertical surface. A vertical surface is needed to insure that
the coin chute within the phone functions properly. Use a spirit level to determine if the
surface is vertical. Use the Level in the following
way:
1. Place the spirit level vertically against the mounting surface on which the Econo Shelf
is to be installed.
2. When a vertical reading is obtained, the end of the Level opposite the point of contact
shall be no farther from the mounting surface than shown in Table
1.
Once a surface has been determined to be vertical, you must obtain the fasteners (screws)
necessary to mount the Econo Shelf. The fasteners must be 1/4 inch in diameter. Refer to
Table 2. (Note: When additional security is required, use through-wall fasteners.)
A hole is usually drilled through the wall (at Econo Shelf wire-entrance point) for the
telephone line cord, pow er cable, and ground wire before the Econo Shelf is installed. The
modular phone jack and pow er transformer can be protected against vandalism by a special
Adapter Kit, KS-23412, for the Econo Shelf.
Mounting Econo Shelf to Wall without Adapter Kit
To mount an Econo Shelf to a wall:
1. Either drill a hole through the wall for the 2-conductor telephone line cord, power
cable, and ground wire, or use the vertical groove on the backw all of the Econo Shelf
for placement of the line cord, power cable, and ground wire. (The groove provides
both wire placement and flush surface mounting.)
2. Install the mounting bracket to the wall (49 inches from the floor) using appropriate
fasteners. The fasteners must be 1 /4 inch in diameter. Refer to Figure 13.
3. Place 2-conductor telephone line cord, pow er cable, and ground wire as required.
(Either through hole in wall or taped to wall so that a groove on the Econo Shelf can
be placed over the wiring).
4. Bring line cord, power cable, and ground wire through center hole in back panel
(outside to inside), then hang the enclosure onto the wall bracket and attach enclosure
to wall with six (6) 3/8 inch diameter flat head screws. Mounting holes are provided in
the back panel of the shelf. Refer to Figure 13. (The Econo Shelf should be flush
against the wall, and should not pinch any wiring.)
5. Mount phone to back panel. Refer to the "Mounting the AT&T Private Pay Phone Plus
to Econo Shelf" description in this section.
Owner Manual Page 34
To Next Page
Loading...
