TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus
1. Removing and Replacing the Coin Box
To Remove the Coin Box
1. Turn power OFF.
2. Unlock the coin vault lock on the lower right side of the phone.
February, 1988
3. Insert and turn the T-key into the coin vault door lock to release and remove the coin
vault door.
4. Pull on the coin box handle (use pliers if necessary) to remove the coin box from the
coin vault. (Note: Pull the coin box straight out.)
To Replace the Coin Box
1. Reset lock on top of coin box by pushing IN with a screwdriver and turning. Refer to
Figure 29.
2. Place coin box back into coin vault (handle facing out), and push in. (Note: When
pushing the :oin box into the vault, apply pressure at the top front surface and sli\,lhtly
more pressure to the left side. Refer to Figure 29.)
3. Replace coin vault door and secure with T-key.
4. Lock coin vault. (The lock is on lower-right side of the phone.)
5. Turn power back ON.
Figure 29 Coin Box
8 Removing and Replacing the LOUD Button Assembly
Turn power OFF. Locate two nuts inside the front of the phone, behind the LOUD button.
Using a 3/8" socket, unscrew the nuts and remove the plate. Disconnect the wires from the
terminal board and pull out the LOUD button assembly. Retighten screws where other wires
are still connected.
To replace the assembly, insert the wires from the new component through the bottom hole.
Seat the new assembly on the front of the phone, making sure the wires stay at the bottom
slot of the bottom hole. Replace the plate, making sure the slot end is down so as not to
interfere with the wires. Replace nuts and reconnect the wires at terminals 2 and 11. A red
wire is also connected at terminal 2, so make sure that wire is still on the terminal. Turn
pow er back ON.
Owner Manual
Page 70
To Next Page
Loading...
