TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus February, 1988
5. Removing and Replacing the Return Chute
To Remove the Plastic Return Chute Assembly:
1. Turn power OFF.
2. Remove the coin chute. (Refer to "Remove the Coin Chute" section in this Chapter.)
3. Loosen the return chute assembly mounting screw and screw bracket. Refer to Figure
27.
4. Pull up on the return chute assembly and remove it from the phone.
RETURN CHUTE
ASSEMBLY
RETURN CHUTE
ASS EMBLY MOUNTING
SCREW
0
Figure 27 Return Chute
To Replace the Plastic Return Chute Assembly:
DUST
COVER
1. Push the return chute assembly down into its mounting hole. The return chute's
mounting slot should align with its screw mounting hole. (The plastic hooks on the
side of the return chute should hook onto the side of the Hopper Assembly.)
2. Replace and tighten the return chute assembly's mounting screw. (Note: Make sure
the mounting screw's bracket is in place.)
3. Replace the coin chute. (Refer to "Replace the Coin Chute" section in this Chapter.)
4. Turn pow er back ON.
Owner Manual
Page 68
To Next Page
Loading...
