TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus February, 1988
To Replace the Coin Chute:
1. Attach the 47A2. Signal Unit (totalizer) to the coin chute.
2. Refer to Figure 26.
3. Make sure the power supply cables are routed below the coin chute and against the
back wall. Make sure that the coin slot on the coin chute is facing towards you. Close
the upper plate assembly of the coin chute, and snap the coin entrance slot back
(Figure 24) into place.
4. Making sure the power supply cables are routed below the coin chute and against the
back wall, place the coin chute back into the base housing. The coin chute should be
aligned with the locating pins. Push the coin chute back until it is against the back wall
of the base housing.
5. Push up on the latch above the coin chute on the base housing (the latch automatically
resets the spring), and then push latch down.
COIN CHUTE LATCH
COIN CHUTE LOCATING PIN
3 TILT TOP LEFT
2 TILT TOP
BACK
COIN CHUTE
Figure 26 Coin Chute
6. Insert the coin chute plug into its connector that is located below the internal keypad
and latch.
7. Replace plastic cover that protects the chassis, and then screw plastic cover to
chassis.
8. Turn pow er back ON.
Owner Manual
Page 67
To Next Page
Loading...
