TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus
February, 1988
6. Removing and Replacing the Coin Return
To Remove the Coin Return Assembly
1. Turn power OFF.
2. Remove the coin chute. (Refer to "Remove the Coin Chute" section in this Chapter.)
3. Remove the plastic return chute assembly. (Refer to "Remove the Return Chute
Assembly" section in this Chapter.)
4. Remove the coin return holding screw. Refer to Figure 28.
5. Pry loose and then pull out the coin return assembly from the front of the phone. (Pull
forward and lift up, then rotate the bottom out and up.)
COIN RETURN
HOLDING SCREW
COIN RETURN--+-+++•
ASSEMBLY
0
Figure 28 Coin Return
To Replace the Coin Return Assembly
1. Insert the coin return assembly into its slot on the front of the phone.
2. Replace and tighten the coin return holding screw. Refer to Figure 28.
3. Replace the plastic return chute assembly. (Refer to "Replace the Return Chute
Assembly" section in this Chapter.)
4. Replace the coin chute. (Refer to "Replace the Coin Chute" section in this Chapter.)
5. Turn power back ON.
Owner Manual Page 69
To Next Page
Loading...
