TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus
February, 1988
D. Final Installation Procedures
Have The Pay Phone Programmed
The pay phone must be programmed so it can charge correctly. Contact the person who is
doing the programming to report that the phone is installed.
Confirm That The Pay Phone Is Operating Properly
Appendix C is a checklist for testing the pay phone's installation and programming. You will
want to remove that page and make as many copies as there are pay phones to install. Fill
out the forms as you go through the tests.
The following will be necessary to perform these tests.
1. Assistants w horn you will be calling from the pay phone. (You will need to place both
local and long distance calls.)
2. A watch that can measure seconds
3. Enough change for placing at least eight calls, two which must be long distance
4. Copies of Appendix C
Instruction and Number Cards
Two Instruction Cards containing dialing information are shipped as part of the AT&T Private
Pay Phone Plus package. Refer to Figure
21. You will have to write or type some
information on the card (see Figure
21). If you plan to have additional cards made,
weatherproof bristol paper
(100-150 lb.) is recommended.
NOTICE
AT&T is not responsible for the information typed or written on cards. The owner must
check with the Public Utilities Commission (P.U.C.) about what is needed for the area in
which the phone is installed.
Owner Manual
Page
50
To Next Page
Loading...
