TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus
ECONO SHELF
WALL MOUNTING HOLES (6)
COCT
MOUNTING HOLES (7)
0
Figure 13 Mounting Econo Shelf
Mounting Econo Shelf to Wall
with Adapter Kit
To mount an Econo Shelf and Adapter Kit to a wall:
February, 1988
~
WIRE ENTRANCE GROOVE
~WIRE ENTRANCE
/
.~ BRACKET GROOVE
WALL BRACKET
1. Install the mounting bracket to the wall (49 inches from the floor) using appropriate
fasteners. The fasteners must be 1 / 4 inch in diameter. Refer to Figure 13.
2. Hang the enclosure onto the wall bracket, and attach the enclosure to wall with six (6)
3/8 inch diameter flat head screws. Mounting holes are provided in the back panel of
the shelf. Refer to Figure 13. (The Econo Shelf should be flush against the wall, and
should not pinch any wiring.)
3. Cut a clearance hole into the bottom molding of the Econo Shelf (at vertical groove).
The clearance hole will provide access to the wire routing groove on the backwall of
the shelf.
Owner Manual Page 35
To Next Page
Loading...
