TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus
February, 1988
4. Remove cover of adapter, and center adapter enclosure under shelf as shown in
Figure 14.
5. Use indoor adapter enclosure as a template and mark mounting holes (4). If power is
to be accessed through wall, mark telephone and electrical access holes (2). Refer to
Figure 14.
6. Drill holes.
7. Attach adapter enclosure to wall using appropriate fasteners for wall type. Refer to
Table 2.
8. Power the duplex receptacle (110 Vac) within the adapter enclosure in accordance
with your local electrical codes. (Note: Access receptacle through wall or from below
adapter enclosure. A ground screw is located within the receptacle box.)
9. Power the telephone connecting block within the adapter enclosure in accordance
with AT&T installation instructions for modular jack 625T
J. (Note: Access telephone
connecting block through wall or from below adapter enclosure.)
10. Use the slot in the top rear of the adapter enclosure for access to the vertical groove
on the backwall of the Econo Shelf when running wires from telephone. Replace
cover of adapter enclosure when telephone is powered up.
Owner Manual
Page 36
To Next Page
Loading...
