TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus
February, 1988
Figure 14 Econo Shelf with Adapter Kit
' MODULAR 2 CONDUCTOR
TELEPHONE LINE CORD -
(FROM CONNECTING BLOCK)
KS-22235, LIST 1 ECONOSHELF-
OR
KS-22235, UST 2 MINI-ECONOSHELF
CUT A CLEARANCE HOLE
IN MOLDING FOR RACEWAY ACCESS-
CONNECTING BLOCK 625T
J-----
(FURNISHED WITH KS-23142 INDOOR ADAPTER)
TELEPHONE POWER CABLE ------'
(ACCESS THRU WALL OR FROM BELOW)
KS-23412 INDOOR ADAPTER
(COVER REMOVED)
• POWER CABLE (0-STATION WIRE)
(FROM POWER TRANSFORMER)
12 AWG GROUND WIRE
(CONNECTION CAN BE MADE TO GROUND SCREW
IN RECEPTACLE BOX IF REQUIRED)
• COMPONENTS FURNISHED WITH
AT&T PRIVATE PAY PHONE
- • POWER TRANSFORMER
(24VAC)
TO
DUPLEX RECEPTACLE
ELECTRICAL POWER (110 VOLTS, AC)
(ACCESS THRU WALL OR FROM BELOW)
~
PLUGGED HOLES
Mounting the AT&T Private Pay Phone Plus to Econo Shelf
Before attempting to mount the phone, familiarize yourself with the phone parts illustrated in
Figure 8. Then do the following steps to mount an AT&T Private Pay Phone
Plus on to an
Econo Shelf:
1. Perform Steps 1-5 In The "Mounting the AT&T Private Pay Phone
Plus without an
Enclosure" Description Above.
2. Mount phone's housing
• Place the electrical power cable, ground wire, and 2-conductor telephone line cord
through the wire entrance hole in the phone (outside to inside). Refer to Figure 7.
• Cut the rubber grommet and bring electrical power cable, ground wire, and
telephone line cord through the center hole of grommet. Refer to Figure 10.
• Place the rubber grommet back into the base housing {thus sealing the opening in
the back of the base housing). See Figure 10.
• Have an assistant hold the phone's housing against the back panel of Econo Shelf
with holes aligned.
• Insert the seven mounting screws (make sure the phone is vertical) and tighten (see
Figure 9). The phone housing should now be firmly mounted against back panel of
Econo Shelf.
3. Perform Steps 9 - 16 in the "Mounting the AT&T Private Pay Phone
Plus without an
Enclosure" Description Above.
Owner Manual
Page 37
To Next Page
Loading...
