TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus
COIN CHUTE LATCH
POWER SUPPLY----1
INTERNAL KEYPAD
TELEPHONE JACK
COIN CHUTE PLUG
COIN RELAY COVER
RED STATIC WIRE
CONNECTION
February, 1988
MOUNTING SCREW FOR PROTECTIVE COVER
CHASSIS MOUNTING SCREW
FRONT COVER DIAL ASSEMBLY
CORD
FRONT COVER
T-KEY
UPPER HOUSING LOCK
COIN VAULT LOCK
Figure 8 Pay Phone Components
Perform the following steps to mount the phone onto a wall with or without a backboard:
1. Remove Front Cover From Phone
• Ref er to Figure 8 .
• Use the correct key, it should be labeled 29A or 298, to unlock the front cover lock
on the right side of the phone.
NOTE The key that locks and unlocks the front cover lock (right side) will only
work for the phone (or phones if a group purchase is made) that it came with.
Label the key and phone set(s) .
• Insert the T-key into the keyhole on the left side of phone, and unlock the front
cover of the phone by turning the T-key counterclockwise. Do not remove the T-
key .
• Gently pull the front cover from the base housing. Unplug the front cover dial
assembly cord from its socket underneath the internal keypad within the base.
2. Remove coin chute
• Refer to Figure 2.
Owner Manual
Page 25
To Next Page
Loading...
