AT&T Plus - Page 32

TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus
February, 1988
• If a terminal block is on the power supply board, tighten each terminal block screw
so that wires are locked into place. Refer to Figure 12. Gently pull each wire
within the terminal block to confirm the connection.
RED I YELLOW/CT
----- GREEN/L 1
------ BLACK/L2
TERMINAL BLOCK
I
L POWER SWITCH
., 0
~
0 0
0
Figure 11 Wiring Connectors On Pow er Supply Board
11. Replace coin box and coin vault door
• Push in and reset the lock inside the coin box cover. Refer to Figure 12.
• Place coin box back into coin vault (handle facing out), and push straight in. (Note:
When pushing the coin box into the vault, apply some pressure at the top front
surface and slightly more pressure at the left side. See Figure 12.)
• Replace coin vault door and secure with T-key.
• Lock coin vault. (The lock is on low er-right side of the phone.)
Owner Manual
Paqe 30