TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus February, 1988
• Make sure that all connections, including the small and large ribbon connections,
are secure.
13. Plug 2-Conductor Telephone Line Cord Into Phone
• Plug the end of the telephone line cord inside the base housing into the modular
telephone jack located below the internal keypad. (Note: Make sure the modular
line cord is placed so that the coin chute will fit back into place.) Refer to Figure 8.
NOTE If the telephone line wire cord you are using does not have a plug, purchase a
700A4 telephone wire plug from your local AT&T Phone Center. Follow the instructions
that come with the plug, but attach the telephone wire to the plug by stripping the
outer jacket from the telephone wire. Place the red wire into the "G' hole, and place
the green wire into the "R' hole. Cut off the yellow and black wires {be sure you don't
connect them). USE A TWO-CONDUCTOR LINE CORD
ONLY unless you are installing an
additional phone (see Appendix
A)
14. Replace Coin Chute
• Refer to Figures 5 and 8.
• Make sure that the coin slot on the coin chute is facing towards you .
• Place the coin chute back into the base housing. The coin chute should be aligned
with the locating pins. Push the coin chute back until it is against the back wall of
the base housing. Make sure the power supply cables are routed below the coin
chute and against the back wall. Refer to Figure 5 .
• Push up on the latch on the phone's housing above the coin chute (the latch
automatically resets the spring), and then push the latch down.
• Plug the coin chute plug into its socket below the internal keypad and latch.
• Replace the plastic cover that protects the chassis, and then tighten screw .
• If the power supply board has a power switch, turn it to ON position.
15. Establish Electrical Power
The transformer, power cable, and telephone line cord should be protected from
vandalism (covered and hidden from view). A "double transformer" (COMCODE 405-
382-383) is available for instances where two phones are to share one transformer.
To power up the AT&T Private Pay Phone
Plus
WARNING
TO REDUCE THE RISK OF ELECTRICAL SHOCK, DISCONNECT POWER TO THE
RECEPTACLE BEFORE INSTALLING OR REMOVING THE UNIT. TAPE THE COVER PLATE
TO THE RECEPTACLE BOX OR WHEN REMOVING THE RECEPTACLE COVER SCREW,
COVER MAY BECOME DISPLACED AND FALL ACROSS PLUG PINS .
• Connect power cable to AC. transformer. Determine the length of power cable
needed to reach the AC. Transformer. Cut off any excess cable.
• Refer to Figure 4.
Owner Manual
Page 32
To Next Page
Loading...
