AT&T Plus - Page 76

TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus February, 1988
• An AT&T 4-Conductor line cord in the required length.
• An AT&T 2670 T-Adapter.
Perform the following to link an additional telephone to your AT&T Private Pay Phone
Plus.
1. Refer to Figure A-1.
2. Follow the installation instructions in Section
3. Instead of using the 2-conductor line
cord supplied with the Private Pay Phone for installation (as stated in Section
3), use
the 4-conductor line cord that you purchased. Connect the 4-conductor telephone line
cord to your Private Pay Phone.
3. Plug the AT&T 2670 T-Adapter into a modular telephone line jack.
4. Connect the other end of the 4-conductor line cord coming from the Private Pay Phone
into the socket labeled "PHONE" on the AT&T 2670 T-Adapter.
5. Plug the line cord from the other telephone into the socket labeled "LINE 2" on the
AT&T 2670 T-Adapter.
EXCLUSION FEATURE CONNECTION WITHIN 25 FT OF PRIVATE PAY PHONE
.-------.ADDITIONAL TELEPHONE LINE CORD
PRIVATE
PAY
PHONE
- [j
4 CONDUCTOR LINE CORD
(7, 14. OR 25 FT)
2670 ADAPTER -
TO ADDITIONAL S'ET
K
L MODULAR PHONE JACK
Figure A-1. Wiring For less than 25-Ft. Distance Between Telephones
METHOD 2: More Than 25 Ft.
If you need more than 25 feet of 4-conductor telephone line cord, the following items are
used:
• D-Station Wire in the required length.
• 4-Conductor line cord in the required length.
• An AT&T 2670 T-Adapter
• Two RJ 14 telephone jacks (not including Private Pay Phone telephone jack). Refer to
Figure A-2.
Perform the following to link an additional telephone to your Private Pay Phone:
1. Implement the wiring layout shown in Figure A-2 below.
2. Follow the installation instructions in Section 3. Instead of using the 2-conductor line
cord supplied with the Private Pay Phone for installation (as stated in Section 3), use
the 4-conductor line cord that you purchased. Connect the 4-conductor telephone line
Owner Manual
Page 2