Need help?Do you have a question about the ATEN CS1944DP and is the answer not in the manual?
General| Ports | 4 |
|---|---|
| Port Type | DisplayPort |
| Number of computers connected | 4 |
| Number of local users supported | 1 |
| Audio Support | Yes |
| HDCP Support | Yes |
| EDID Management | Yes |
| Maximum Resolution | 3840 x 2160 @ 60Hz |
| Switching Method | Hotkey |
| Device Type | DisplayPort KVM Switch |
| Resolution | Up to 3840 x 2160 @ 60Hz |
Introduces the RS-232 serial interface capabilities and usage for system control.
Instructions for installing necessary applications, like HyperTerminal, for RS-232 control.
Guides on physically connecting the computer to the device using an RS-232 serial adapter.
Step-by-step process for establishing a HyperTerminal session and configuring port settings.
Explains how to interpret command execution success or failure messages for commands sent.
Commands to establish and terminate the RS-232 communication link with the device.
Command to select and switch between different input ports on the KVM switch.
Command to configure the serial port's communication speed (baud rate).
Command to change the keyboard language layout for device input.
Command to change the hotkey used to invoke the Hotkey Setting Mode.
Command to change the hotkey used for switching between connected computers.
Command to reset the USB connection for troubleshooting or re-initialization.
Command to reset all device settings back to their factory default values.
Command to enable the device's firmware upgrade mode for updates.
Command to display the device's current configuration status and settings.
To Next Page
