SELECTING A PROGRAM
If necessary, you can select another program.
1. Press up/down .
STARTING AND STOPPING CURRENT CYCLE
Use the front panel keys to start/stop a measurement cycle.
With the desired program displayed on the Program screen:
STARTING A MEASUREMENT CYCLE
1. Press Start .
The cycle phases of the program are successively
displayed:
WAITING
FILL
STABIL.
TEST
DUMP
At the end of the cycle, the results are displayed and
READY appears at the bottom right of the screen.
During the measurement cycle, you may press to
access the MAIN MENU screen and set parameters for
a next measurement cycle.
STOPPING A CYCLE
2. Press Reset to immediately stop the current
measurement cycle and return to the Program
screen.
To Next Page
Loading...
