2 General description
2.1 General description
Introduction
The air dryers described in this book are heatless adsorption dryers, built to remove moisture from
compressed air for industrial purposes.
The dryer is intended to reach a pressure dew point of -40 ˚C (-40 ˚F). A pressure dew point of -70 °C (-94
°F) can be achieved by decreasing the inlet flow rate (see inlet flow correction factors, section Technical
data).
All units are designed for indoor use, and altitude up to 2000 m.
CD 1
+
up to CD 3
+
, General view
Instruction book
2920 7083 21 9
To Next Page
Loading...
