Elektronikon Graphic controller
Control panel of Elektronikon Graphic controller
1. Regularly check the display for readings and messages. Normally, the main display is
shown.
2. Always check the display and remedy the trouble if alarm LED (4) is alight or blinks.
The display will show a service message if a service plan interval has been exceeded or if a
service level for a monitored component has been exceeded. Carry out the service actions
of the indicated plans or replace the component and reset the relevant timer.
Regularly check the Inputs and Outputs menus for a quick look at the compressor status.
5.6 Stopping
Important
After pressing the stop button, the compressor will run unloaded for 30 seconds. The
compressor stops after this period. A start command during this period is ignored.
After stopping, the compressor is prevented from restarting within a programmable time
(20 seconds). A start command given during this minimum stop time will be memorized;
the automatic operation LED lights up. The compressor will start when the minimum
stop time has elapsed.
Instruction book
60 APF221384
To Next Page
Loading...
