• Press the key ‘Prog’ (F1) to program the new value or the key ‘Canc’ (F3) to cancel the modification
operation (the original value will be retained).
• The procedure to modify other parameters is similar.
3.22 Programming compressor control modes
Control panel
Compressor control modes
The compressor can be controlled locally, remotely or via a local area network (LAN).
Procedure
Starting from the Main screen (see Main screen menu):
• Press the key ‘Menu’ (F1).
• Press the arrow down key (1) until ‘Modify Params’ is followed by an arrow pointing to the right.
• Activate the menu by pressing tabulator key (2).
• Press the arrow down key (1) to scroll until ‘Configuration’ is followed by a horizontal arrow.
• Activate the menu by pressing tabulator key (2): the first item ‘Time’ will appear. Scroll through the
display using the scroll keys (1) until the option ‘C.C.M.’ is followed by a horizontal arrow and select it
using the tabulator key (2). The following screen is shown:
‘C.C.M.’
‘Local Control’
.
‘Menu’ ‘Mod.’
F1 F2 F3
• Press the key ‘Mod.’ and use the scroll keys (1) to select the desired control mode. Press the key ‘Prog’
to program or the key ‘Canc’ to cancel the modification.
Instruction book
50 2920 1634 04
To Next Page
Loading...
