Atlas Copco LF 100 - Start and Stop; Honda; Before Starting, Honda; Starting the Engine, Honda

♦
The tilting angle is measured on a hard level
surface with the machine stationary. Vibration
switched OFF and all tanks full.
Start and stop
Honda
Before starting, Honda
Follow the general safety precautions supplied with
the machine at delivery. We recommend to study the
engine manual supplied with the machine. Check
that maintenance routines have been carried out.
♦
Check the engine oil level on the dipstick.
♦
Fill the fuel tank with fuel.
♦
Check that all the controls are working.
♦
Make sure that there is no oil leakage, and that
all bolted joints are tightened.
♦
After the engine is started, leave the speed control
in the idling position for a few minutes to warm up
the engine without loading it.
Starting the engine, Honda
1. Open the fuel cock (A).
2. Set the throttle control (B) to
1
⁄ 3 throttle.
3. Close the choke valve (C) if the engine is cold.
If the engine is warm or the ambient temperature
is high, close the choke valve halfway or leave
it open.
© 2015 Construction Tools EOOD | No. 9800 1125 01c | 2015-05-26
Original instructions
18
LF 100Safety and operating instructions