Atlas Copco LF 100 - Starting the Engine, Hatz; Stopping the Engine, Hatz

1. Check the engine oil level on the dipstick.
2. Fill the fuel tank with fuel.
3. Check that all the controls are working.
4. Make sure that there is no oil leakage, and that
all bolted joints are tightened.
5. When you have started the engine, leave the
speed control in the idling position for a few
minutes to warm up the engine without loading
it.
Starting the engine, Hatz
1. Set the throttle control (A) to half throttle.
2. Grip the recoil starter handle (B) with both hands
and pull until it resists. Return the handle to the
initial position, then pull sharply and at an
increasing speed (but do not jerk) until the engine
starts.
Stopping the engine, Hatz
♦
Put the throttle control (A) in the middle position.
If the exhaust begins to emit white smoke, after
several attempts of starting, do the following:
© 2015 Construction Tools EOOD | No. 9800 1125 01c | 2015-05-26
Original instructions
20
LF 100Safety and operating instructions