Atlas Copco LF 100 - Operating; Handle Positions

1. Move the throttle control to the stop position.
2. Slowly pull the starting cable out 5 times.
3. Repeat the starting procedure.
Operating
NOTICE Always operate the machine at full speed,
otherwise it prevents the eccentric element from
compacting correctly. It can result in machine failure.
Handle positions
NOTICE Always operate the machine forwards,
otherwise it opposes the force of the eccentric
element which works in a forward direction. Turn the
machine around to prevent machine failure.
Raise the handle to the operating position:
1. Loosen the knobs (A).
2. Raise the handle from the folded position.
3. Tighten the knobs when the upper handle (B) is
in the correct position.
Fold the handle to the transport position:
1. Loosen the knobs (A) and lower the handle on
top of the machine.
2. Tighten the knobs.
♦
Raise the handle to turn the machine on the
spot:
Raise the handle to a 90° angle towards the
ground, to turn the machine on the spot. This
function may be useful in a small narrow place or
on uneven ground.
21© 2015 Construction Tools EOOD | No. 9800 1125 01c | 2015-05-26
Original instructions
Safety and operating instructionsLF 100