Atlas Copco LF 100 - Changing the Engine Oil, Hatz; Every 100 Hours of Operation (Weekly); Checking the V-Belt

6. Fill with oil (C).
7. Refit the dipstick (D).
8. Start the engine and allow the engine to idle a
few minutes before increasing to full power.
Changing the engine oil, Hatz
1. Unscrew the drainage plug (A).
A
A
B
2. Tilt the machine backwards and let the oil drain
in a drainage hose.
3. Clean around the drainage plug (A).
4. Screw on the drainage plug (A).
5. Refill with oil at (B) and refit the dipstick.
6. Start the engine and allow the engine to idle a
few minutes before increasing to full power.
Every 100 hours of operation
(weekly)
Maintenance routines
Applies to all:
♦
Check the shock absorbers.
♦
Check the engine speed.
♦
Check that the V-belt is not damaged.
Applies to Honda engines:
♦
Change engine oil. See engine manual for more
information.
♦
Check and clean the spark plug. See engine
manual for more information.
♦
Clean the carburettor's fuel cock. See engine
manual for more information.
♦
Clean the silencer's spark catcher. See engine
manual for more information.
CAUTION Cover the V-belt
Running a machine without the protective cover over
the V-belt may cause trapping or machine damage,
which can cause injury.
► Never run the machine without the protective cover
over the V-belt.
► Stop the engine before removing the protective
cover.
Checking the V-belt
The V-belt must be checked and adjusted by
authorized service personnel.
© 2015 Construction Tools EOOD | No. 9800 1125 01c | 2015-05-26
Original instructions
24
LF 100Safety and operating instructions