Atlas Copco MT Focus 6000 User Manual

Quick start guide EN MicroTorque
2
© Atlas Copco Industrial Technique AB - 9839 1629 01
Quick start guide
1. Connect the tool to MT Focus 6000 using a MT tool cable.
2. Connect MT Focus 6000 to power supply. Make sure to switch on the power supply to start the con-
troller.
WARNING Risk of Injury
The tool may rotate when the system is switched on and the tool is initializing.
► Keep body parts, hair and clothing away from the tool.
3. Connect MT Focus 6000 to a PC with a USB cable or an ethernet cable.
4. Open ToolsTalk MT on the PC. The following are the commonly used configurations to start up:
■ Buttons and lights configurations:
■ Tool configurations:
■ Controller configurations:
For more information, refer to ToolsTalk MT Configuration Manual (98390526).
5.
Create a Pset in ToolsTalk MT to set up a tightening program.
For more information, refer to ToolsTalk MT Configuration Manual (98390526).
6. Mount the bit and activate Pset. Adjust Pset settings if needed.
Refer to PI for instructions of mounting the bit.

Atlas Copco MT Focus 6000 Specifications

General

Brand	Atlas Copco
Model	MT Focus 6000
Category	Controller
Language	English