Atlas Copco TPS Control - User Manual

TPS Control
Printed Matter No. 9836 5819 01 Control and drive unit
Publication Date 2018-02-23
Valid for Version No. 1.2
User Guide
WARNING
Read all safety warnings and instructions
Failure to follow the safety warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference

Atlas Copco TPS Control Specifications

General

Brand	Atlas Copco
Model	TPS Control
Category	Controller
Language	English

Summary

Introduction

Safety and Operating Instructions

Read and comply with all safety warnings and instructions for safe operation.

System Overview

Describes how to install, configure, and use the Tool Positioning System (TPS) Control.

TPS Controller Hardware

User Interface

Explains operation via the front panel's graphical display and keyboard.

Connections and Interfaces

Encoder Connections

Details analogue and SSI encoder connections.

Power Supply and Serial Interfaces

ToolsTalk TPS Software

System Setup

Starting TPS

Outlines the initial steps to start the TPS controller.

Setting Up System Parameters

Explains how to configure general system parameters like language and special functions.

Configuration Settings

Input;Output Parameters

Details configuration of input/output signals for communication with tool controllers.

Encoder Parameters

Covers setting position parameters for analogue and SSI encoders on torque arms.

Tool System Integration

Connecting to Power Focus 4000

Details configuration for communication between TPS and Power Focus 4000.

MicroTorque G4 Integration

ToolsTalk MT Configuration (MicroTorque G4)

Configuration steps within ToolsTalk MT software for MicroTorque G4.

Installing I;O Extension Board

Installation Procedure

Step-by-step guide for installing the I/O extension board.

Operation

Job Handling

Explains how to manage, create, and start programmed jobs.

Maintenance

Firmware Updates

Explains the process of updating the TPS controller firmware.

System Parameters

Core System Parameters

Details parameters like station number, tool model, position control, etc.

Input Configuration

Output Configuration

Positioning Parameters

Torque Arm Type Configuration

Defines the type of torque arm used with the TPS system.

Troubleshooting Common Errors

Clutch Too Late Errors

Error message and solutions for clutch engaging too late.

Barcode Functionality

Reporting Functionality

Printout Procedures

Guides on printing data from TPS Control to a PC via RS-232 interface.