Atlas Copco TPS Control - System Setup; Starting TPS; Setting Up System Parameters

TPS Control EN User guide
© Atlas Copco Industrial Technique AB - 9836 5819 01
9
In ToolsTalk TPS you can do the following:
■
Handle TPS Control configuration files (select/read/write)
■
Configure connection between PC and TPS Control
■
Change language (ToolsTalk TPS)
■
Handle report function (configure/create)
■
Import licenses for optional functions
■
Update firmware in TPS Control
Setup
Starting TPS
1. Connect cables and ground connection according to section TPS Controller.
2. Switch on the power. The controller starts up immediately.
Setting up TPS
Setting up system parameters
This section describes how to set up general system parameters in TPS.
1. Press MENU.
2. Press SETUP.
3. The default language is English. If you want to change the language, go to Service and press OK to
enter the menu.
4. Select the appropriate language in User language. Confirm your selection with OK. Possible lan-
guages are English, German or French.
5. Press VAL to change to the selected language.
6. Go to System parameter and press OK to enter the menu.
7. Set Special functions to ON to view advanced programming functions. Press OK.
8. Enter values for additional parameters. The parameters and options are described in detail in section
System Parameters [Page000].
9. Press VAL to confirm changes or ESC to quit without making any changes.