TPS Control EN User guide
© Atlas Copco Industrial Technique AB - 9836 5819 01
3
User guide
Introduction
Safety and operating instructions
WARNING Read all warnings and all instructions.
The safety and operating instructions as described in the Atlas Copco Product instructions that is included
in the delivery of the system must be read and complied. Ensure that you read and understand all instruc-
tions. Failure to follow all the instructions may result in electric shock, fire and/or serious personal injury.
All locally legislated safety regulations with regard to installation, operation and maintenance must be ad-
hered to at all times. Refer installation and servicing to qualified personnel only.
Save all instructions for future reference.
Contact your Atlas Copco representative if questions regarding the safety and operating instructions arise.
System overview
This user guide describes how to install, configure and use the Tool Positioning System (TPS) Control.
TPS Control is used for controlling and monitoring the tightening sequences and positioning operations for
a variety of pneumatic and electronic tools. The TPS Control system is designed for the modern assembly
industry with high demands on quality and production efficiency, and offers full modularity through the
combination of different hardware and software.
A typical setup of the TPS contains the controller itself connected to a screwdriver and torque arm, with
external operating and display elements and a digital I/O cable to a tool controller.
To Next Page
Loading...
Need help?
General
