Atlas Copco U190 PACE KD WUX User Manual

- 42 -
STARTING
During initializing all buttons/inputs/outputs/alarms
are inactive.
This view will be shown for about 2 seconds, after
which the display will show the Main View.
The actual vessel pressure is shown. If the measured
vessel pressure is higher than 1.5 bar, the unit will not
start. The vessel pressure has to be lowered by
opening the blow down valve. After power up, the
vessel pressure normally is low enough to proceed
with the starting procedure.
The display will change to
followed by
The machine is now ready to be started and is waiting
for a start command.
The display will change to
The engine electronics (ECU) will be powered up.
As soon as communication between compressor
controller and engine controller is established, the
machine will preheat according to the parameters of
the engine controller.
If the Power button is switched to switch
off while the vessel is blowing down, it
will not power down for as long as the
vessel pressure is higher than 1.5 bar.
Active Buttons
Active Buttons
VUE PRINCIPALE
NAVIRE EN COURS DE SOUFFLAGE
3,9
1300RÉGIME 1286h
40%
430
40%
VUE PRINCIPALE
PRÊT À DÉMARRER
0,0
--RÉGIME 0,0bar
40%
1286h
VUE PRINCIPALE
LECTURE DES DONNÉES MOTEUR
0,0
-- RÉGIME 0,0bar
40%
1286h

Atlas Copco U190 PACE KD WUX Specifications

General

Brand	Atlas Copco
Model	U190 PACE KD WUX
Category	Air Compressor
Language	English