- 23 -
Starting / Stopping
Safety precautions
Battery switch
If the compressor is equipped with a battery switch:
When the compressor is not in use this switch must always
be in the “OFF” position.
It is not allowed to use this switch as an emergency switch
or for stopping the compressor. It will cause damage in the
control unit when using this switch for stopping.
Always first shut off the control unit and wait until the
display is dark before switching the battery switch to
position “OFF”.
Control panel
Do not disconnect power supply to control
box in any way when the control box is
switched on. This will cause memory loss.
Do not switch off the circuit breaker when
the control box is switched on. This will
cause memory loss.
Please be aware that the (optional)
preheater unit is still “live” with the battery
switch in “OFF” position.
Reference Name
START BUTTON: This button will initiate
the starting sequences if the controller is in
Ready To Start Sequence, or will re-enter the
normal running sequence when in Cooldown
Sequence.
STOP BUTTON: This button will initiate the
cooldown/stopping sequences if the controller
is in normal running sequence.
LOAD BUTTON: This button has been
disabled. The compressor is constantly loaded.
MEASUREMENTS VIEW BUTTON: This
button will enter the Measurements View when
not already in the Measurements View, or
when already in the Measurements View it will
enter the Main View.
SETTINGS VIEW BUTTON: This button
will enter the Settings View when not already
in the Settings View, or when already in the
Settings View it will enter the Main View.
ALARMS VIEW BUTTON: This button will
enter the Alarms View when not already in the
Alarms View, or when already in the Alarms
View it will enter the Main View.
NAVIGATION BUTTONS: These buttons
are used to navigate through the display
menu’s.
ENTER BUTTON: Confirms/stores the
selection/change.
BACK BUTTON: Moves back one level or
ignores the change.
To Next Page
Loading...
Need help?
General
