- 52 -
Air Receiver
The air receiver is tested according to official standards.
Regularly have inspections carried out in conformity with
local regulations.
Safety Valve
Following checks must be carried out:
– a check of the opening of the lifting gear, twice a year.
This can be done by lifting the ring or lever.
– a check of the set pressure once a year according to the
local regulations. This check cannot be done on the
machine and must be carried out on a proper test bench.
Fuel System
Replacing the filter element:
1. Unscrew the final filter element from the adapter head.
2. Clean the adapter head sealing surface. Lightly oil the
gasket of the new element and screw the latter onto
the header until the gasket is properly seated, then
tighten with both hands.
3. Do not fill with fuel before assembling new filter.
Filling the fuel filter introduces dirty (unfiltered) fuel
to the injectors.
4. After replacing the final filter’s element, prime fuel
system with manual prime bulb located below the
fuel filter’s housing.
5. Check for fuel leaks once the engine has been
restarted.
All adjustments or repairs are to be done by
an authorized representative of the valve
supplier.
To Next Page
Loading...
Need help?
General
