Caution 5
Atlas Cyclops
Caut ion
Any damage caused by failure to follow the instructions in this manual or
improper machine use shall relieve Atlas Equipment of all liability.
Preliminary Safety Information
Before starting the machine:
• Read the instructions and the entire manual before using or working on
the wheel aligner. This manual represents an integral part of the product
and is intended to inform the user on how to use the Atlas Cyclops wheel
aligner. Keep the manual for the entire life of the machine. Keep it in an
easy to access place and refer to it every time the need arises. All machine
operators must be able to read the manual.
• Make sure the power supply is in conformity with the specifi cations shown
on the plate. Voltage and frequency data plate is positioned on machine
back side. Please, read plate data. NEVER connect aligner to a voltage or
frequency other than the specifi ed ones.
• Duly arrange wheel aligner power cable. This product features a 3-wire
plug with built-in grounding. It can be plugged into a socket with built-in
grounding, only. Should a grounded socket not be available for machine
connection, contact an electrician. Do not tamper with or misuse plug.
Upon machine switching off:
• Do not switch off the built-in PC by unplugging it or by turning PC switch to
off, but follow the procedure set forth in part 6.2. Improperly switching off
the PC could lead to HARD-DISK fi les “corruption”.
• The switching off procedure set forth in part 6.2 does not affect battery
recharge supports, which continue being powered.