Troubleshooting 73
Atlas Cyclops
Troubleshoot ing
Some of the most common problems that could arise on wheel aligners are listed
here below. Atlas Equipment declines all liability for injury or damage to persons,
animals and properties caused by the intervention of unauthorized personnel,
and by the use of non-original spare parts.
Before doing any operation on the system, always disconnect the power supply.
In case of doubt, do not interpret, but contact Atlas Equipment technical
assistance in order to obtain instructions suitable for performing operations in
total safety.
TROUBLE CAUSE REMEDY
NO OPERATION
• No main voltage
• Interrupted
protection fuses
• Check main voltage
• Check protection fuses
Monitor does not work
• No supply voltage
• No video signal
• Check power cable
connection
• Check video signal cable
connection between PC
and monitor
PC cannot be switched
on
• No supply voltage
• Check PC ON/OFF switch
• Check power cable
connection
Printer does not work
(see also printer user’s
manual)
• No supply voltage
• No signal
• Check ON/OFF voltage
• Check power cable
connection
• Check printer signal
cable connection with PC
To Next Page
Loading...
Need help?
General
