Errors During Measurement 72
Atlas Cyclops
If both symbols are BLUE, the error in Figure 61 may signal a failed identifi cation
of the target/s, caused by one or more of the problems listed below
• Camera covered (cap on).
• Obstruction between target and camera.
• Target not mounted or not in the correct position (see part 9.2.2)
• Camera broken
If the cause of failure is eliminated (ex. obstruction between target and camera
is removed) the error page will immediately disappear, and the measurement
page will be displayed again. If the problem continues, check system hardware
by switching machine off. Of course, it is not recommended to abruptly power
cabin off; follow the correct switching off procedure:
• Press “Esc” on keyboard to go back to the introduction page (see part10).
• Switch machine off following the usual procedure (see part 6.2).
To Next Page
Loading...
Need help?
General
