Operator Training 8
Atlas Cyclops
Operat or Training
The machine must be used by specifi cally trained and authorized personnel,
only. To ensure proper machine use and that measurements can be effi ciently
taken, operators must be correctly trained and acquire the skills consistent with
the instructions provided by the manufacturer. For any questions on the use and
maintenance of the machine, please read the instruction manual or the manuals
supplied with the individual pieces of equipment (PC, monitor, printer, ...) and
then, if such doubts persist, contact an authorized after-sales center or Atlas
Equipment technical assistance directly.
2.1 General Preventive Measures
• During operation and maintenance of this machine, always abide
by the safety and accident-prevention regulations in force.
• The machine must only be used by adequately trained and
authorized persons.
• This machine must only be used for the purpose for which it was
expressly intended. Atlas Equipment declines all liability for injury
or damage to persons, animals, and things caused by improper
machine use.
• Accessories and spare parts must be fi tted by persons authorized
by Atlas Equipment and only original spare parts and accessories
must be used.
• The machine must only be operated in places where there is no
danger of explosions or fi re.
• Removal or changes made to safety devices, or warning signals on
the machine can cause serious hazards and represent a violation
of safety regulations.
• Before doing any maintenance jobs on the system, always
disconnect the power supply. In case of doubt, do not interpret,
but contact Atlas Equipment technical assistance in order to obtain
instructions suitable for performing operations in total safety.
• Do not allow unauthorized personnel to come near the wheel
aligner during use.
To Next Page
Loading...
Need help?
General
