Atmor InLine 800 Series - Operation Guide; Troubleshooting; Water Not Hot Enough

Operation Guide
Troubleshooting
7
PROBLEM ISSUE POSSIBLE CAUSE SOLUTION
Water not hot
enough.
Too much water owing
through the heater.
Reduction in the ambient
temperature.
Water Pressure below of
0.5 bar (7 psi).
Electrical Malfunction.
Reduce the ow rate of the water via
the outlet tap.
Switch to higher temperature setting.
Check if the main water line stop
valve is fully open and that there
are no other restrictions in the water
supply line.
Have the Heater unit check by a
qualied eIectrician or contact your
local authorized distributor.
MODEL kW kW kW kW
AT-800-35 0 1 2 3.5
AT-800-04 0 1.6 2.2 3.8
AT-800-70 0 3 3.5 7
AT-800-08 0 3.8 4.7 8.5
AT-800-10 0 5.25 5.25 10.5
AT-800-13 4.5 8.5 13
LOWOFF MED HIGH
0
L
O
W
M
I
D
H
I
G
H
0
L
O
W
M
I
D
H
I
G
H
0
L
O
W
M
I
D
H
I
G
H
0
L
O
W
M
I
D
H
I
G
H