1-4
To remove the microSD Card from the slot, push it in
using the same thin object. When it pops up a few millime-
ters, it can be pulled with your fingers or tweezers.
NOTE
If you are going to record video we recommend
using a Class 10 microSD card (10 MB/sec) or faster
and have capacity from 4 to 64 GB.
1.04. FIRMWARE UPDATE
Before operating your device please
update the firmware to the latest version.
To receive a notification of new firmware
updates, please register your device on
our website (you’ll receive an email letting
you know when new firmware becomes
available).
To update the new firmware you will
need a microSD Card and batteries that
are fully charged.
NOTE
In the event of a power failure during an update the device may crash corrupting its
system files and will need to be sent back to the ATN factory for service. It is important
not to use additional sources of power during firmware update!
Update the new firmware as follows:
1. Download the ***.bin file and copy to your microSD Card – root directory
2. Insert the card into the device
3. Turn ON the device
4. In the “Firmware Update” dialog box select “Yes” to start the update
5. When the update counter reaches “100%” the device will automatically restart
6. Once the device is powered up it will enter self configuration mode
7. After completion, it will automatically restart and will be ready for use
8. Motion Sensing platform will be configured when first turned on.
NOTE
If the device does not restart within 30 seconds, remove and re-insert the batteries and
power-up the device.
NOTE
Once the device has been updated you will need to either format the card or delete
the update file manually. In the event you do not, the system will ask you if you wish to
update the device every time you turn it on.
To Next Page
Loading...
