What to do if IR source fails to activate on ATN Binoculars?
If the IR source on your ATN Binoculars fails to activate, ensure you are in a dark location with the system turned on, then activate the IR source. Visually check the IR source operation; the scene should brighten.
How to fix poor image quality on ATN Binoculars?
To address poor image quality with your ATN Binoculars, try refocusing the device. Additionally, ensure that you clean the lens surfaces.
What to do if ATN Binoculars monocular does not cut off in bright light?
If your ATN Binoculars monocular does not cut off when exposed to high light, perform the following test under daylight or bright room light (avoid fluorescent light): Place the objective lens cap on the objective lens. Turn the monocular ON and observe that it cuts off within 70 ±30 seconds after being energized. Turn the monocular OFF and then ON to reenergize the monocular.
How to fix ATN Binoculars when the monocular fails to activate?
If the monocular on your ATN Binoculars fails to activate, turn the power switch to the RESET/ OFF position and then back ON. If it still doesn't work, replace the battery or ensure it is installed correctly.
Why is there light visible around the eyecup of my ATN Binoculars?
If you see light visible around the eyecup of your ATN Binoculars, readjust for proper eye relief distance. If the eyecup is defective, it may require a higher level of maintenance.
What to do if headmount adapter latch does not catch on ATN Binoculars?
If the headmount or helmet mount socket and headmount/ helmet mount adapter latch on your ATN Binoculars do not catch, clean the socket and latch. If they are damaged, it may require a higher level of maintenance.
Why diopter adjustment cannot be made on ATN Binoculars?
If the diopter adjustment on your ATN Binoculars cannot be made, check to see if the diopter adjustment is bent or broken.
How to fix compass display if it is not clear on ATN PVS-14?
If the compass display on your ATN Binoculars is not clear, make sure the monocular is focused for infinity. If the compass display is still not clear, it may require a higher level of maintenance.
What to do if LIF will not thread in or obstruct view on ATN Binoculars?
If the LIF on your ATN Binoculars will not thread in or obstructs the view, clean the threads. If it is damaged, it may require a higher level of maintenance.
General handling and operational precautions for the night vision device.
Critical warnings regarding toxic materials, power, and safe usage practices.
Outlines procedures and schedules for routine maintenance and checks of the equipment.
Step-by-step guide for unpacking, installing batteries, and attaching accessories.
Instructions for using the device in various configurations and scenarios.
General| Magnification | 1x |
|---|---|
| Objective Lens Diameter | 27 mm |
| Field of View | 40° |
| Water Resistance | Yes |
| Focus Range | 0.25 m to infinity |
| Operating Temperature | -40°C to +50°C |
| Battery Life | 50 hours |
| Resolution | 64-72 lp/mm |
| Diopter Adjustment | +2 to -6 |
| Power Source | 1x AA battery |
| Type | Monocular |
To Next Page
