ATN PVS-14 - RESOLUTION CHECK AND DEFECT INSPECTION

2-14

  
NOTE


NOTE
-
-

Set.
NOTE
    
-
rately measured without the test set.
The following procedures are designed to check the performance
of the image intensifier.
a. Setup
Before using the TS-4348/UV Test Set to set up and familia-rize
yourself with its operation and the warnings and cautions associ-
ated with that test equipment.
NOTE
        


        
        


       

Set.

Test the monocular for low light and high light resolution perfor-
mance according to the following steps.
(1)
 