3-6
PROCEDURES
3.3.1. CLEANING THE MUNVM
CAUTION
your fingers.
lens paper can damage the coating.
Clean monocular with water if necessary and dry thoroughly. Clean
lenses with lens paper (and water if necessary, except for the de-
mist shield).
Replace the browpad when cracked, torn, or contaminated. Per-
form the following procedures to remove and replace the browpad.
(1) Firmly grasp the headmount and remove the old browpad.
(2) Gently press on the new browpad. Lightly smooth out any wrin-
kles in the new browpad.
During operation of the MUNVM, it is possible for the neck pad to
become separated from its position on the headband. Perform the
following procedure to reinstall the neck pad.
(1) Lift the upper headband strap retention tab (see Figure 3.1) al-
lowing the neck pad strap to be inserted underneath.
(2) Slip the neck pad strap all the way under the upper strap reten-
tion tab and then pull the lower part of the neck pad strap under the
lower strap retention tab.
(3) Repeat steps 1 and 2 for the other side of the headband and
neckband if necessary.
To Next Page
Loading...
Need help?
General
