ATOMSTACK A12 PRO - Offline Mode Autofocus; Lightburn Automatic Focus Control

6. Autofocus
6.2.3 Oine mode:
Open the "Autofocus" function on the display screen, then select the program to be engraved, click "Focus" to peorm automatic focus.After nding the upper
limit and the lower limit at the current position, the laser automatically lifts to the xed focal distance.Then click "Sta" to sta engraving.
6.2.4 Lightburn Automatic Focus Control:
a) Open Lightburn and locate the console, right-click on "Macro 0"
to open a window.
b) Enter [ESP500] in "Macro Contents" and click OK to
complete the setup.
12345.gc
6
1
2
1
2