ATOMSTACK Befon A5 Pro Plus User Manual

Shenzhen AtomStack Technologies Co., Ltd. support@atomstack3d.com
d. Click on the following two buttons in sequence to move the laser
so that the laser point moves to the center of the engraving. Once
the positioning is complete, you can start engraving.
Picture
4
.3 center point positioning
5. Common materials and recommended engraving and cutting
parameters
Table 5.1 Laser GRBL software common material engraving and cutting
parameter table recommendation

ATOMSTACK Befon A5 Pro Plus Specifications

General

Brand	ATOMSTACK
Model	Befon A5 Pro Plus
Category	Engraver
Language	English