FAQ
1. How to deal with the edge collision in Step 6.3 calibration camera alignment?
Check whether there is a phenomenon that the captured image is severely deformed and you continue to click Next during the process of
calibrating the camera lens. If yes, please recalibrate the camera lens.
2. How to deal with the positioning accuracy error > 2mm?
1) During the process of calibrating the camera lens, whether there is a phenomenon that the captured image is seriously deformed and
you continue to click Next? If yes, please recalibrate the camera lens.
2) After the calibration of camera alignment is completed, whether there is a collision or the camera is moved, if the camera is collided
and the camera is displaced left and right, please recalibrate the camera lens and the camera alignment.
3.Does it need to be recalibrated when changing the material to be tested, removing or adding honeycomb panels?
The height range between the camera and the measured object can be between 400-440mm, and no recalibration is required for changing
the tested material, removing or adding honeycomb panels.
11
To Next Page
Loading...
Need help?
General
